inside screw
英 [ˌɪnˈsaɪd skruː]
美 [ˌɪnˈsaɪd skruː]
网络 内螺纹; 内螺纹阀杆; 内螺丝
双语例句
- Inside screw lift check valve
内螺纹升降式止回阀 - Steamer inside out material passes through the discharging screw to a1feeder;
蒸锅里面出来的料经过出料螺杆送到打料机； - Tapping is the process of cutting a thread inside a hole so that a cap screw or Bolt may be threaded into it.
攻丝是在一个孔中车出螺纹，以便装上有帽螺钉或螺栓。 - Study on the Reliability of Calculating Joint inside Force in Inverse Dynamics; Application of absorbable screw in treatment of scaphoid fracture by retrograde internal fixation
应用逆向动力学计算关节内力的可靠性分析逆行可吸收拉力螺钉内固定治疗腕舟骨骨折 - The characters and factors were analyzed when the laser probe measurement was used in inside screw surface.
分析了激光光针扫描在测量内螺纹曲面时的特性及影响精度的因素。 - Development of a Device Measuring Inside Screw
内螺纹测量装置的开发 - The three-dimensional potential flow inside the impeller of a screw centrifugal pump was analysed by the boundary element method.
采用边界元法对螺旋离心泵叶轮中的三维势流进行了数值计算。 - Outside the core, the stresses are the same as that of Volterra dislocation, but inside the core, the stresses of the screw dislocation approach zero when ρ goes to zero.
在螺位错芯区外，其应力场与Volterra位错的应力场完全一样，而在芯区内，当ρ趋于零时，螺位错的应力场是有解的。 - Boundary Element Method for Three-dimensional Potential Flow inside Impeller in Screw Centrifugal Pump
螺旋离心泵叶轮中三维势流的边界元法 - This paper introduces the structure, the principle and the operation of a device measuring inside screw developed by the authors.
介绍自行开发的内螺纹中径测量装置的构成、原理和使用方法。 - Analyses of cavity formation reason inside a screw pole
螺杆心部空洞形成原因分析 - Measuring for the Pressure inside the Squeezing Cylinder of a Screw Oil Mill
螺杆式榨油机膛内压力的测试 - Leakage magnet detection system for inside screw steel pipes and flaw indentification
内螺纹钢管的漏磁检测方法与缺陷识别 - Measurement of inside screw curve surface by laser probe
光针轮廓扫描技术测量内螺纹曲面 - The experimental results was showed that the former one is sensitive to bolt root crack defects, but not good to defect inside the screw; the latter one is well in the screw of crack testing, but not well in the root of bolt crack testing.
通过检测实验结果表明：前者对螺栓根部的裂纹缺陷有良好的灵敏度，但对螺纹内缺陷检测效果不佳；后者对螺纹内的裂纹检测效果良好，但对螺栓根部裂纹检测信噪比差。